Aztek, Rendezvous 2001-2005

Disarming the System

Print

  1. Turn the wheels to the straight-ahead position, then turn the ignition switch to LOCK .
  2.  
  3. Remove the console accessory wiring junction block access hole cover.
  4.  
  5. Remove the "AIR BAG" or "SIR" fuse from the block, as applicable.
  6.  
  7. Remove the left-hand sound insulator, for access to the SIR wiring harness.

    Click image to see an enlarged view

    Fig. Driver-s side air bag connector location



    Click image to see an enlarged view

    Fig. Passenger-s side air bag connector location



    Click image to see an enlarged view

    Fig. Side air bag connector location

  8.  
  9. Remove the Connector Position Assurance (CPA) device, then disengage the yellow 2-way connector at the base of the steering column.
  10.  
  11. Remove the right hand insulator panel.
  12.  
  13. Remove the CPA from the inflatable restraint instrument panel module connector located behind the RH insulator panel.
  14.  
  15. Disconnect the instrument panel module connector
  16.  
  17. If equipped with side air bags, remove the CPA from the inflatable restraint side impact module-left front connector located under the driver seat.
  18.  
  19. Disconnect the side impact module-left front connector.
  20.  
  21. Remove the CPA from the inflatable restraint side impact module-right front connector located under the front passenger seat.
  22.  
  23. Disconnect the side impact module-right front connector.
    NOTE
    With the fuse removed, the AIR BAG or SIR light will illuminate if the ignition switch is turned ON at any time. This is normal and does not indicate a problem when the system is disarmed.

  24.  

 
label.common.footer.alt.autozoneLogo