Aztek, Rendezvous 2001-2005

Wheel Speed Sensors

Print

Removal & Installation




NOTE
The front wheel speed sensors and rings are integral with the hub and bearing assemblies. If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Do not service the harness pigtail individually because the harness pigtail is part of the sensor.

  1. Raise and support the vehicle on a suitable hoist.
  2.  
  3. Remove the front tire and wheel assembly.

    Click image to see an enlarged view

    Fig. Remove the front wheel speed sensor jumper harness electrical connector (1)from the front wheel speed sensor connector (3).

  4.  
  5. Remove the front wheel speed sensor jumper harness electrical connector from the front wheel speed sensor connector.
  6.  
  7. Remove the hub and bearing assembly.
  8.  

To install:

  1. Install the hub and bearing assembly to the vehicle.
  2.  
  3. Install the front wheel speed sensor jumper harness electrical connector to front wheel speed sensor connector .
  4.  
  5. Install the wheel and tire assembly.
  6.  
  7. Lower the vehicle.
  8.  
  9. Turn the ignition switch to the RUN position with the engine off.
  10.  


NOTE
The rear wheel speed sensors and rings are integral with the hub and bearing assemblies. If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly.

  1. Raise and support the vehicle on a suitable hoist.
  2.  
  3. Remove the rear tire and wheel assembly.
  4.  
  5. Remove the rear wheel speed sensor electrical connector located next to the rear strut.
  6.  
  7. Remove the hub and bearing assembly.
  8.  

To install:

  1. Install the hub and bearing assembly to the vehicle.
  2.  
  3. Install the rear wheel speed sensor electrical connector.
  4.  
  5. Install the wheel and tire assembly.
  6.  
  7. Lower the vehicle.
  8.  
  9. Turn the ignition switch to the RUN position with the engine off.
  10.  

 
label.common.footer.alt.autozoneLogo