Aztek, Rendezvous 2001-2005

3.6L Engine

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Turn the ignition OFF .
  4.  
  5. Remove the fuel pump fuse and the fuel pump relay.
  6.  
  7. Loosen the fuel filler cap to relieve the fuel tank vapor pressure.
  8.  
  9. Attempt to start the engine and allow the engine to run until it stops.
  10.  
  11. Remove the fuel pressure test port cap.
    CAUTION
    Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the connection of the fuel pressure gage is complete.

  12.  
  13. Wrap a shop towel around the fuel pressure test port and use a small flat-bladed tool in order to depress (open) the fuel pressure test port valve.
  14.  
  15. Place the shop towel in an approved container.
  16.  
  17. Install the fuel pressure test port cap.
  18.  
  19. Tighten the fuel filler cap.
  20.  

 
label.common.footer.alt.autozoneLogo