BMW X5 2000-05

Hydraulic Control Module

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the control unit. For additional information, refer to the following topic, -Control Module, Removal & Installation-.
  4.  
  5. Match mark and detach the brake lines from the hydraulic control model.
  6.  
  7. Remove the screws and pressure sensor.
  8.  
  9. Remove the mounting bolts and detach the control module.
  10.  
  11. Installation is the reverser order of removal.

    Click image to see an enlarged view

    Fig. Location of the brake lines to the hydraulic control module.



    Click image to see an enlarged view

    Fig. Remove the pressure sensor before removing the control module.

  12.  

  1. Disconnect the negative battery cable.
  2.  
  3. Unplug the wiring harness located in front of the control module for access.
  4.  
  5. Remove the screws and detach the control unit from the hydraulic unit.

    Click image to see an enlarged view

    Fig. Disconnect the wiring harness by unlocking (1), pulling out (2) and pulling up (3)



    Click image to see an enlarged view

    Fig. Remove the screws (1) to pull the control module off the hydraulic unit.

  6.  

To install:

  1. Clean the surface of the hydraulic unit.
  2.  
  3. Carefully push the control unit onto the hydraulic unit.
  4.  
  5. Install the screws, but do not tighten until the control unit rests evenly on the hydraulic unit.
  6.  
  7. The remainder of the installation is the reverse order of removal.
  8.  

 
label.common.footer.alt.autozoneLogo