BMW X5 2000-05

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. On 3.0L engines, remove the heater bulkhead as follows:
    1. Pull off the weatherstrips on top of the bulkhead.
    2.  
    3. Release the cowl retaining toggle clips.
    4.  
    5. Lift out the cover.
    6.  
    7. Remove the screws and remove the heater bulkhead.
    8.  

  6.  
  7. Remove or disconnect the following:

    Heater hoses from firewall connections
     
    Air duct for left footwell from mountings
     
    Left footwell vent
     
    Heater pipes from under dash
     
    Heater duct for right footwell
     
    Air duct for rear footwell on right
     
    Cover from heater housing
     
    Evaporator temperature sensor (pull out to one side)
     
    Heater core
     

  8.  

To install:

  1. Install or connect the following:

    Heater core
     
    Evaporator temperature sensor
     
    Heater housing cover
     
    Air ducts in footwells
     
    Heater pipes under dash
     
    Heater hoses at firewall connections
     
    Heater bulkhead (3.0L)
     

  2.  
  3. Reconnect the negative battery cables
  4.  
  5. Check coolant level
  6.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. On 3.0L engines, remove the heater bulkhead as follows:
    1. Pull off the weatherstripping on top of the bulkhead.
    2.  
    3. Release the cowl retaining toggle clips.
    4.  
    5. Lift out the cover.
    6.  
    7. Remove the screws and remove the heater bulkhead.
    8.  

  6.  
  7. Remove or disconnect the following:

    Heater hoses from firewall connections
     
    Air duct for left foot well from mountings
     
    Left foot well vent
     
    Heater pipes from under dash
     
    Heater duct for right foot well
     
    Air duct for rear foot well on right
     
    Cover from heater housing
     
    Evaporator temperature sensor (pull out to one side)
     
    Heater core
     

  8.  

To install:

  1. Install or connect the following:

    Heater core
     
    Evaporator temperature sensor
     
    Heater housing cover
     
    Air ducts in foot wells
     
    Heater pipes under dash
     
    Heater hoses at firewall connections
     
    Heater bulkhead (3.0L)
     

  2.  
  3. Reconnect the negative battery cables
  4.  
  5. Check coolant level
  6.  

 
label.common.footer.alt.autozoneLogo