Bonneville, LeSabre, Park Avenue 2000-2005

Oil Pressure Sensor

Print

Removal & Installation



  1. Raise and support the vehicle
  2.  
  3. Disconnect the electrical connector from the engine oil pressure switch (1).
  4.  
  5. Remove the engine oil pressure switch from the oil filter adapter using the Oil Pressure Socket J-41712.
  6.  

To install:

  1. Install the engine oil pressure switch to the oil filter adapter using the special socket.
  2.  
  3. Tighten the engine oil pressure switch to 12 ft. lbs. (16 Nm).
  4.  
  5. Connect the electrical connector to the engine oil pressure switch.
  6.  
  7. Lower the vehicle.
  8.  
  9. Inspect for oil leaks after engine start up.
  10.  
  11. Adjust the engine oil level to the full mark.
  12.  

 
label.common.footer.alt.autozoneLogo