Breeze, Cirrus, Sebring Convertible and Sedan, Stratus Sedan, 1999-2005

Bleeding the Brake System


For bleeding the ABS hydraulic system refer to the 4-Wheel Anti-Lock Brake System (ABS) section of this manual.

Before removing the master cylinder cap, wipe it clean to prevent dirt and other foreign matter from dropping into the master cylinder reservoir.

Use only MOPAR® brake fluid, or equivalent, from a fresh, tightly sealed container. Brake fluid must conform to DOT 3 specifications.

Do not pump the brake pedal at any time while having a bleeder screw open during the bleeding process. This will only increase the amount of air in the system and make additional bleeding necessary.

Do not allow the master cylinder reservoir to run out of brake fluid while bleeding the system. An empty reservoir will allow additional air into the brake system. Check the fluid level frequently and add fluid as needed.

The following wheel circuit sequence for bleeding the brake hydraulic system should be used to ensure adequate removal of all trapped air from the hydraulic system.

Left rear wheel
Right front wheel
Right rear wheel
Left front wheel