CR-V 2007-2008

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the glove box.
  4.  
  5. Remove the glove box frame.
  6.  
  7. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown. Retain the plastic cross brace as it will be reinstalled.

    Click image to see an enlarged view

    Fig. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown

  8.  
  9. Remove the wire harness clips (A), the self-tapping screws, and the passenger's heater duct (B).

    Click image to see an enlarged view

    Fig. Remove the wire harness clips (A), the self-tapping screws, and the passenger's heater duct (B)

  10.  
  11. Disconnect the connector (A) from the blower motor. Remove the wire harness clip (B).
  12.  
  13. Disconnect the connector from the recirculation control motor. Remove the self-tapping screws, the bolt, the mounting nuts, and the blower unit.
  14.  

To install:

  1. Install the unit in the reverse order of removal.
  2.  
  3. Make sure that there are no air leaks.

    Click image to see an enlarged view

    Fig. Blower unit installation

  4.  

 
label.common.footer.alt.autozoneLogo