CR-V 2007-2008

Exterior

Print

Back-up, Brake, Marker, Signal, & Tail Lights



Removal & Installation
Tail Lights
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Open the tailgate.
  4.  
  5. Remove the caps and mounting bolts from the taillight (A), then carefully pull off the taillight.
  6.  
  7. Turn the bulb sockets (B) 45° counterclockwise to remove them from the housing.
  8.  
  9. If replacement of the taillight harness is necessary, remove the grommet (C), and disconnect the 6P connector (D) from the side wire harness.
  10.  

To install:

  1. Install the taillight in the reverse order of removal.
  2.  
  3. Check taillights for proper function.

    Click image to see an enlarged view

    Fig. Exploded view of taillight assembly

  4.  

Headlights



Removal & Installation
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the front bumper and the front fender trim.
  4.  
  5. Remove the connectors (A) from the headlight assembly (B).
  6.  
  7. Remove the harness clips, screw, clip, and 3 bolts, then remove the headlight assembly with the corner upper beam (C).
  8.  
  9. Remove the bolt (D) and the corner upper beam from the headlight.
  10.  

To install:

  1. Install the headlight in the reverse order of removal.
  2.  
  3. After replacement, adjust the headlight.

    Click image to see an enlarged view

    Fig. Exploded view of headlight assembly

  4.  

 
label.common.footer.alt.autozoneLogo