CR-V 2007-2008

Bleeding

Print

Specific to:

Honda CR-V 2007-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Stop the engine.
  4.  
  5. Turn the steering wheel fully to the right and left several times.
    NOTE
    Do not allow the fluid level in the reservoir tank to go below the MIN level line. Check and add fluid as needed.

  6.  
  7. Run the engine at idle speed. Turn the steering wheel fully to the right and then fully to the left. Hold for about 3 seconds. Check for fluid leakage.
  8.  
  9. Repeat the above step several times at 3 second intervals.
    WARNING
    Do not hold the steering wheel in the locked position for more than 10 seconds. Damage to the pump may occur.

  10.  
  11. Check for air bubbles or cloudy fluid. If found, repeat the bleeding procedure.
  12.  
  13. Stop the engine and check the fluid level. Correct as required.
  14.  

 
label.common.footer.alt.autozoneLogo