CR-V 2007-2008

Brake Pads

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove a small amount of brake fluid from the reservoir using a suction pump.
  4.  
  5. Remove the lower caliper pin bolt and pivot the caliper upward.
  6.  
  7. Remove the pads, shims, and pad retainers.
  8.  

To install:

  1. Clean the caliper thoroughly; remove any dirt or dust. Check the brake rotor for grooves or cracks and machine or replace, as necessary.
  2.  
  3. Install the pad retainers. Apply molybdenum brake grease to both surfaces of the shims and the back of the disc brake pads.
  4.  
  5. Install the pads and shims. The wear retainer on the inboard pad faces down.
  6.  
  7. Use a suitable tool to push caliper piston into its bore and enable the caliper to fit over the pads. Lubricate the piston boot with silicon grease. Avoid twisting the boot.
  8.  
  9. Rotate the caliper down and tighten the mounting bolts to 17 ft. lbs. (23 Nm)
  10.  
  11. Install the rear wheels.
  12.  
  13. Add brake fluid to the master cylinder reservoir. Depress the brake pedal several times to seat the pads. Bleed the brakes if necessary.
  14.  

 
label.common.footer.alt.autozoneLogo