CR-V 2007-2008

Removal & Installation

Print

Before servicing, or working around, the SRS system, turn the ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. When servicing, or working around, the SRS system do not work directly in front of the air bag module.

Driver-s Side



Specific to:

Honda CR-V 2007-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disable the SIR system. Refer to Air Bag (Supplemental Restraint System), disarming the system.
  4.  
  5. Disconnect the 7P connector (A) from the driver's air mix control motor (B).
  6.  
  7. Remove the self-tapping screws and the driver's air mix control motor from the heater unit.
  8.  

To install:

  1. Install the motor in the reverse order of removal.
  2.  
  3. Make sure the pin on the motor is properly engaged with the linkage.
  4.  
  5. After installation, make sure the motor runs smoothly.

    Click image to see an enlarged view

    Fig. Disconnect the 7P connector (A) from the driver's air mix control motor (B)

  6.  

Passenger-s Side



Specific to:

Honda CR-V 2007-2008

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disable the SIR system. Refer to Air Bag (Supplemental Restraint System), disarming the system.
  4.  
  5. Remove the glove box.
  6.  
  7. Remove the wire harness clips (A), the self-tapping screws, and the passenger's heater duct (B).

    Click image to see an enlarged view

    Fig. Remove the wire harness clips (A), the self-tapping screws, and the passenger's heater duct (B)

  8.  
  9. Disconnect the 7P connector (A) from the passenger's air mix control motor (B). Remove the self-tapping screws and the passenger's air mix control motor from the heater unit.

    Click image to see an enlarged view

    Fig. Disconnect the 7P connector (A) from the passenger's air mix control motor (B)

  10.  

To install:

  1. Install the motor in the reverse order of removal.
  2.  
  3. Make sure the pin on the motor is properly engaged with the linkage.
  4.  
  5. After installation, make sure the motor runs smoothly.
  6.  

 
label.common.footer.alt.autozoneLogo