CTS 2003-2005



Circuit/Component Diagnosis And Repair

The fault codes and the scan tool data will lead to diagnosis and checking of a particular circuit. It is important to note that the fault code indicates a fault or loss of signal in an PCM-controlled system, not necessarily in the specific component.

Refer to the appropriate Diagnostic Code chart to determine the codes meaning. The component may then be tested following the appropriate component test procedures found in this section. If the component is OK, check the wiring for shorts or opens. Further diagnoses should be left to an experienced driveability technician.

If a code indicates the PCM to be faulty and the PCM is replaced, but does not correct the problem, one of the following may be the reason:

There is a problem with the PCM terminal connections: The terminals may have to be removed from the connector in order to check them properly.
The PCM is not correct for the application: The incorrect PCM may cause a malfunction and may or may not set a code.
The problem is intermittent: This means that the problem is not present at the time the system is being checked. In this case, make a careful physical inspection of all portions of the system involved.
Shorted solenoid, relay coil or harness: Solenoids and relays are turned on and off by the PCM using internal electronic switches called drivers. Each driver is part of a group of four called Quad-Drivers. A shorted solenoid, relay coil or harness may cause an PCM to fail, and a replacement PCM to fail when it is installed. Use a short tester, J34696, BT 8405, or equivalent, as a fast, accurate means of checking for a short circuit.
The replacement PCM may be faulty: After the PCM is replaced, the system should be rechecked for proper operation. If the diagnostic code again indicates the PCM is the problem, substitute a known good PCM. Although this is a very rare condition, it could happen.


If a fault occurs intermittently, such as a loose connector pin breaking contact as the vehicle hits a bump, the PCM will note the fault as it occurs and energize the dash warning lamp. If the problem self-corrects, as with the terminal pin again making contact, the dash lamp will extinguish after 10 seconds but a code will remain stored in the computer control module's memory.

When an unexpected code appears during diagnostics, it may have been set during an intermittent failure that self-corrected; the codes are still useful in diagnosis and should not be discounted.

Visual/Physical Underhood Inspection

This is possibly the most critical step of diagnosis and should be performed immediately after retrieving any codes. A detailed examination of connectors, wiring and vacuum hoses can often lead to a repair without further diagnosis. Performance of this step relies on the skill of the technician performing it; a careful inspector will check the undersides of hoses as well as the integrity of hard-to-reach hoses blocked by the air cleaner or other component. Wiring should be checked carefully for any sign of strain, burning, crimping, or terminal pull-out from a connector. Checking connectors at components or in harnesses is required; usually, pushing them together will reveal a loose fit.