CTS 2003-2005

Ignition Switch

Print

Removal & Installation



  1. Disable the SIR system for zone 3.
  2.  
  3. Remove the upper and lower steering column trim covers.
  4.  
  5. Remove the wire harness assembly from the wire harness strap.
  6.  
  7. Remove and dispose of the smaller wire harness straps.
  8.  
  9. Slide the 2 connectors of the turn signal and multifunction switch assembly out of the bulkhead connector.
  10.  
  11. Remove the key alarm connector from the ignition lock cylinder case.
  12.  
  13. Remove the 2 tapping screws from the ignition switch assembly.
  14.  
  15. Remove the ignition switch from the ignition lock cylinder case.
  16.  

To install:

  1. Install the ignition switch replacement and secure by using the 2 tapping screws.
  2.  
  3. Tighten the screws to 62 inch lbs. (7 Nm).
  4.  
  5. Push the key alarm connector into the ignition lock cylinder case.
  6.  
  7. Rotate the key alarm connector 90 degrees so that the key alarm connector locks into place.
  8.  
  9. Install the coded key controller onto the ignition lock cylinder case.
  10.  
  11. Connect the connectors and of the ignition switch replacement.
  12.  
  13. Install the wire harness strap onto the upper tilt head assembly.
  14.  
  15. Install the 3 wire harness straps onto the wire harness assembly.
  16.  
  17. Install the wire harness assembly into the wire harness strap.
  18.  
  19. Install the upper and lower steering column trim covers.
  20.  
  21. Enable the SIR system.
  22.  

 
label.common.footer.alt.autozoneLogo