CTS 2006-2007, CTS-V 2005-2007, DTS 2006-2007

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the primary fuel tank module.
  4.  
  5. Disconnect the fuel level sensor electrical connector from the module.
  6.  
  7. Complete the following in order to remove the fuel level sensor (1) from the module assembly:
    1. Pull the locking tab (2) away from the sensor (1).
    2.  
    3. Slide the sensor (1) away from the module assembly.

      Click image to see an enlarged view

      Fig. Fuel level sensor removal

    4.  

  8.  

To install:

  1. Complete the following in order to install the fuel level sensor (1) to the module assembly:
    1. Align the tabs of the sensor (1) with the slots in the module assembly.
    2.  
    3. Slide the sensor (1) fully into position, ensure the locking tab (2) is engaged.
    4.  

  2.  
  3. Connect the fuel level sensor electrical connector (1) to the module.
  4.  
  5. Install the primary fuel tank module.
  6.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the fuel pump module.
  4.  
  5. Release the fuel level sensor electrical connector clip.
  6.  
  7. Disconnect the fuel level sensor electrical connector (1) from under the fuel module cover.
  8.  
  9. Release the locking tab (2) and slide the fuel level sensor (3) down off of the bucket.

    Click image to see an enlarged view

    Fig. Fuel level sensor (3) locking tab (2) connector (1)

  10.  

To install:

  1. Slide the fuel level sensor (3) up onto the bucket, gently lift up on the locking tab (2) and continue sliding the sensor up until it engages the tab.
  2.  
  3. Connect the fuel level sensor electrical connector (1) under the module cover. Push up the connector until the clip engages.
  4.  
  5. Install the fuel pump module.
  6.  

 
label.common.footer.alt.autozoneLogo