Caliber 2007

Slave (Actuator) Cylinder

Print

Removal & Installation




NOTE
To prevent drainage of clutch master cylinder assembly upon slave cylinder removal, it is necessary to make sure brake master cylinder fluid level is full and reservoir cap is installed tight.

  1. Remove transaxle from vehicle.
  2.  
  3. Remove bolts to slave cylinder-to-clutch bellhousing bolts and remove slave cylinder (1) from transaxle.

    Click image to see an enlarged view

    Fig. Slave cylinder (1)

  4.  

To install:

  1. Install slave cylinder to transaxle using new bolts.
    NOTE
    Torque three CSC body screws first, then torque the fluid tube attachment.

  2.  
  3. Torque slave cylinder-to-case bolts in three steps:

    2 N·m (18 in. lbs.)
     
    5 N·m (44 in. lbs.)
     
    8.4 N·m (74 in. lbs.)
     

  4.  
  5. Install transaxle.
  6.  
  7. Bleed clutch hydraulic system.
  8.  

 
label.common.footer.alt.autozoneLogo