Caliber 2007

Intake Air Temperature Sensor

Print

Operation



The Intake Air Temperature (IAT) sensor is a negative coefficient sensor that provides information to the Powertrain Control Module regarding the temperature of the air entering the intake manifold.

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the Intake Air Temperature (IAT) sensor electrical connector.
  4.  
  5. Remove the IAT sensor.
  6.  

To install:

  1. Install the IAT sensor and ensure the correct sensor orientation.

    Click image to see an enlarged view

    Fig. Showing the correct IAT sensor orientation-2.0L & 2.4L Engines

  2.  
  3. Attach the IAT sensor electrical connector.
  4.  
  5. Connect the negative battery cable.
  6.  

Testing



  1. Turn the ignition off. If possible, allow the vehicle to sit with the ignition off for more than 8 hours in an environment where the temperature is consistent and above 20°F (-7°C).
  2.  
  3. Test drive the vehicle. The vehicle must exceed 30 mph (48 km/h) during the test drive. Do not cycle the ignition off when the test drive is completed.
  4.  
  5. With a scan tool, select View DTCs.
  6.  
  7. If a DTC is not active, perform the following:
  8.  
  9. Refer to any Technical Service Bulletins (TSBs) that may apply.
  10.  
  11. Review the scan tool Freeze Frame information. If possible, try to duplicate the conditions under which the DTC set.
  12.  
  13. With the engine running at normal operating temperature, monitor the scan tool parameters related to the DTC while wiggling the wire harness. Look for parameter values to change and/or a DTC to set. Turn the ignition off.
  14.  
  15. Visually inspect the related wire harness. Disconnect all the related harness connectors. Look for any chafed, pierced, pinched, partially broken wires and broken, bent, pushed out, or corroded terminals. Perform a voltage drop test on the related circuits between the suspected inoperative component and the PCM.
    CAUTION
    Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool no. 8815 to perform diagnosis.

  16.  
  17. Inspect and clean all PCM, engine, and chassis grounds that are related to the most current DTC.
  18.  
  19. If numerous trouble codes were set, use a wire schematic and look for any common ground or supply circuits.
  20.  
  21. For any Relay DTCs, actuate the Relay with the scan tool and wiggle the related wire harness to try to interrupt the actuation.
  22.  
  23. For intermittent Evaporative Emission trouble codes perform a visual and physical inspection of the related parts including hoses and the Fuel Filler cap.
  24.  
  25. Use the scan tool to perform a System Test if one applies to failing component. A co-pilot, data recorder, and/or lab scope should be used to help diagnose intermittent conditions.
  26.  

 
label.common.footer.alt.autozoneLogo