Caliber 2007

Throttle Body

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the engine appearance cover.
  4.  
  5. Remove the air intake assembly.
  6.  
  7. Disconnect the Intake Air Temperature (IAT) sensor and makeup air hose.
  8.  
  9. Disconnect the throttle body electrical connector.
  10.  
  11. Remove the throttle body support bracket.

    Click image to see an enlarged view

    Fig. Remove the throttle body support bracket.

  12.  
  13. Remove the throttle body mounting bolts.
  14.  
  15. Remove the throttle body assembly.
  16.  

To install:

  1. Ensure the throttle body O-ring is in place on the intake manifold.
  2.  
  3. Position the throttle body on the intake manifold alignment pins. Install, but do not tighten the mounting bolts.
  4.  
  5. Install the throttle body support bracket.
  6.  
  7. Tighten the throttle body mounting bolts in a criss-cross pattern to 80 inch lbs. (9 Nm).
  8.  
  9. Connect the throttle body electrical connector.
  10.  
  11. Install the air intake assembly.
  12.  
  13. Connect the IAT sensor and makeup air hose.
  14.  
  15. Connect the negative battery cable.
  16.  
  17. Install the engine appearance cover.
    NOTE
    A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous Menu, and then select ETC Relearn. If the relearn is not performed, a Diagnostic Trouble Code (DTC) will be set. If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTCs) from the Powertrain Control Module (PCM).

  18.  

 
label.common.footer.alt.autozoneLogo