Caliber 2007

Brake Drums

Print

Removal & Installation



  1. Raise and safely support the vehicle.
  2.  
  3. Remove the rear wheel.
  4.  
  5. Slide the brake drum off the wheel mounting studs of the hub and bearing and remove it from the vehicle.
    NOTE
    If the drum does not come off, further brake clearance can be obtained by backing off the brake adjuster screw.

  6.  

To install:

  1. Remove any building formed along the outer edge of the drum-s braking surface.
  2.  
  3. Slide the brake drum on the wheel mounting studs.
  4.  
  5. Install the rear wheel.
  6.  
  7. Lower the vehicle.
  8.  
  9. Test drive the vehicle, stopping in both forward and reverse directions.
    NOTE
    The automatic-adjuster will continue to adjust the brakes as necessary during the road test.

  10.  

 
label.common.footer.alt.autozoneLogo