Caliber 2007

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Drain the cooling system.
  4.  
  5. Remove the accessory drive belt.
  6.  
  7. Raise and safely support the vehicle.
  8.  
  9. Remove the accessory drive belt splash shield.
  10.  
  11. Remove the bolts securing the water pump pulley and remove the pulley.
  12.  
  13. Remove the water pump mounting bolts and remove the water pump.
  14.  

To install:

  1. Install the water pump and tighten the mounting bolts to 18 ft. lbs. (24 Nm).
  2.  
  3. Install the water pump pulley and tighten the pulley bolts to 79 inch lbs. (9 Nm).
  4.  
  5. Install the accessory drive belt splash shield.
  6.  
  7. Lower the vehicle.
  8.  
  9. Install the accessory drive belt.
  10.  
  11. Refill the cooling system to the correct level.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo