Camaro, Firebird, 1999 - 2002

Ignition Lock Cylinder

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
  4.  
  5. Remove the steering wheel from the steering column.
  6.  
  7. Insert the ignition key into the lock cylinder. Leave the key in the LOCK position.
  8.  
  9. Remove or disconnect the following:

    Lock retaining screw
     
    Lock cylinder and harness
     

  10.  
  11. Pull the wire harness through the steering column.
  12.  
  13. Remove the lock cylinder from the steering column.
  14.  

To install:

  1. Install the lock cylinder to the vehicle.
  2.  
  3. Pull the wire harness through the steering column.
  4.  
  5. Connect the retaining clip to the lock housing cover sleeve.
  6.  
  7. Install the wiring protector.
  8.  
  9. Connect the terminal connector to the bulkhead connector and tighten the screw to 22 inch lbs. (2.5 Nm)
  10.  
  11. Remove the ignition key from the lock cylinder.
  12.  
  13. Install the steering wheel to the steering column.
  14.  
  15. Reconnect negative battery cable.
  16.  

 
label.common.footer.alt.autozoneLogo