Camaro, Firebird, 1999 - 2002

Parking Brake Shoes

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Ensure that the park brake control lever is in the fully released position.
  4.  
  5. Raise and support the vehicle.
  6.  
  7. Ensure that both of the park brake actuator levers are in the fully released position. If both of the park brake cable actuator levers are not in the fully released position, adjust the park brake.
  8.  
  9. Remove the tire and wheel.
  10.  
  11. Remove the rear brake caliper bracket with the rear brake caliper.
  12.  
  13. Remove the rear brake rotor.
  14.  
  15. Loosen the park brake actuator adjuster nut until there is no tension against the park brake shoe.
  16.  
  17. Remove the park brake shoe from the backing plate and the park brake shoe retaining clip.
  18.  
  19. Install the park brake actuator retainer to the park brake actuator.
  20.  

To install:

  1. Remove the park brake actuator retainer from the park brake actuator.
    NOTE
    Ensure that the park brake shoe engages the actuator and the park brake shoe retaining clip.

  2.  
  3. Install the park brake shoe to the park brake support plate.
  4.  
  5. Adjust the park brake.
  6.  
  7. Install the rear brake rotor.
  8.  
  9. Install the rear brake caliper bracket with the rear brake caliper.
  10.  
  11. Install the tire and wheel.
  12.  
  13. Lower the vehicle.
  14.  

 
label.common.footer.alt.autozoneLogo