Camry 2007

Wheel Speed Sensors

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the front wheel.
  4.  
  5. Remove the 3 screws and the front wheel opening extension pad
  6.  
  7. Remove the front fender liner.
  8.  
  9. Remove the front speed sensor, as follows:
    1. Disconnect the speed sensor connector and clamp.
    2.  
    3. Remove the 2 bolts and separate the speed sensor harness from the body and shock absorber assembly.
    4.  
    5. Disengage the 2 claws from the steering knuckle.
    6.  
    7. Remove the bolt and the front speed sensor.
      NOTE
      Do not allow foreign matter to attach to the sensor tip.


      NOTE
      Clean the installation hole and surface for the speed sensor every time the speed.

    8.  

  10.  

To install:


NOTE
Do not twist the wire harness for the front speed sensor when installing the speed sensor.


NOTE
The bolt B tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.


NOTE
Install the stopper firmly to the hole in the body.

  1. To install, reverse removal procedure.
  2.  
  3. Tighten the front speed sensor with the bolt to 71 inch lbs. (8 Nm).
    NOTE
    Do not allow foreign matter to attach to the sensor tip.

  4.  
  5. Tighten the sensor harness brackets with the 2 bolts to the body and shock absorber assembly and 44 inch lbs. (5 Nm), and then to 14 ft. lbs. (19 Nm).
  6.  
  7. Install the front wheel and tighten the lug nuts to 76 ft. lbs. (103 Nm).
  8.  
  9. Check ABS speed sensor signal.
  10.  

 
label.common.footer.alt.autozoneLogo