Camry 2007

Fuel Pump

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Discharge fuel system pressure.
  4.  
  5. Disconnect battery negative cable.
  6.  
  7. Remove the rear seat cushion assembly.
  8.  
  9. Remove the rear floor service hole cover.
  10.  
  11. Disconnect the fuel pump connector.
  12.  
  13. Separate the fuel pump tube sub-assembly, as follows:
    NOTE
    Check if there is any dirt or mud around the connector before this operation and remove the dirt as necessary.


    NOTE
    Be careful of mud because the quick connector has an O-ring which seals the pipe and connector that can be contaminated.


    NOTE
    Do not use any tools in this operation.


    NOTE
    Do not bend or twist the nylon tube. Cover the fuel tube joint with a plastic bag.


    NOTE
    When the fuel tube joint and fuel suction plate are stuck, pinch the fuel tank tube between fingers, and turn it carefully to release it. Disconnect the fuel tank tube.

    1. Remove the tube joint clip, and pull out the fuel pump tube.

      Click image to see an enlarged view

      Fig. Fuel pump tube sub-assembly

    2.  

  14.  
  15. Remove fuel tank vent tube set plate, as follows:
    1. Remove the 8 bolts and set plate.
    2.  

  16.  
  17. Remove fuel suction tube assembly with pump and gauge, as follows:
    1. Pull out the fuel suction tube from the fuel tank.
      NOTE
      Do not damage the fuel pump filter.


      NOTE
      Be careful not to bend the arm of the fuel sender gauge.

    2.  
    3. Remove the gasket from the fuel suction tube.
    4.  

  18.  

To install:

  1. Install a new gasket to the fuel suction tube.
  2.  
  3. Install the fuel suction tube.
    NOTE
    Do not damage the fuel pump filter.


    NOTE
    Be careful not to bend the arm of the fuel sender gauge.

  4.  
  5. Install the fuel tank vent tube set plate, as follows:
    1. Align the mark of the set plate with the fuel suction tube.
    2.  
    3. Install the set plate with the 8 bolts and tighten to 52 inch lbs. (5.9 Nm).
    4.  

  6.  
  7. Install the fuel pump tube with the tube joint clip.
    NOTE
    Check that there is no scratches or foreign objects on the connecting part.


    NOTE
    Check that the fuel tube joint is inserted securely.


    NOTE
    Check that the tube joint clip is on the collar of the fuel tube joint.


    NOTE
    After installing the tube joint clip, check that the fuel tube joint is pulled off.



    Click image to see an enlarged view

    Fig. Fuel pump tube joint clip

  8.  
  9. Connect battery negative cable.
  10.  
  11. Inspect for fuel leak.
  12.  
  13. Install the rear floor service hole cover.
  14.  
  15. Install the rear seat cushion assembly.
  16.  

 
label.common.footer.alt.autozoneLogo