Camry 2007

Service Plug Grip

Print

Removal & Installation




CAUTION
Remove the service plug grip to interrupt a high voltage circuit at the time of the check.

Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

All the high voltage wiring connectors are orange colored.

Be sure to turn the power switch off before removing the service plug grip.

  1. Check for DTCs Confirm that P0AA6 (High voltage insulation is unusual) is not output before doing removal or installation work inside the battery. If the DTC is output, perform troubleshooting procedures first.
  2.  
  3. Release the 2 claws and remove the luggage trim service hole cover.

    Click image to see an enlarged view

    Fig. Luggage trim service hole cover

  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Slide the latch upward and open the service hole cover.
  8.  
  9. Wear insulated gloves. Remove the service plug grip after sliding the lever of the service plug grip.

    Click image to see an enlarged view

    Fig. Removing the service plug grip

  10.  

To install:

  1. Install the service plug grip.
  2.  
  3. Connect the negative battery cable.
  4.  
  5. Install the luggage trim hole cover.
  6.  
  7. Perform the initialization procedure.
    NOTE
    Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.

  8.  

 
label.common.footer.alt.autozoneLogo