Camry 2007

Exterior Lighting

Print

Back-up, Brake, Marker, Signal, & Tail Lights



Removal & Installation
Tail Lights
  1. Before servicing the vehicle, refer to the Precautions Section.
    1. For vehicles with rear lower spoiler, perform the following:
    2.  
    3. Remove the 4 screws, 2 clips, 3 nuts and rear floor board.
    4.  

  2.  
  3. Put protective tape around the rear bumper assembly.
    NOTE
    Tape the screwdriver tip before use

  4.  
  5. Using a screwdriver, open the 2 rear bumper plates.
  6.  
  7. Remove the 6 screws and 2 clips.
  8.  
  9. Disengage the 12 claws and disconnect the rear bumper assembly.
  10.  
  11. Remove the rear bumper assembly.

    Click image to see an enlarged view

    Fig. Removing rear bumper assembly

  12.  
  13. Remove luggage compartment floor mat.
  14.  
  15. Remove spare wheel cover clamp.
  16.  
  17. Remove luggage compartment side tray assembly.
  18.  
  19. Remove no. 1 luggage compartment trim hook.

    Click image to see an enlarged view

    Fig. Removing luggage compartment door cover

  20.  
  21. Remove rear floor finish plate.
  22.  
  23. Remove the rear combination light assembly, as follows:
    1. Disconnect the connector.
    2.  
    3. Remove the 3 nuts.
    4.  
    5. Disengage the clip and remove the rear combination light assembly.

      Click image to see an enlarged view

      Fig. Identifying taillight components (1 of 2)



      Click image to see an enlarged view

      Fig. Identifying taillight components (2 of 2)

    6.  

  24.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  

Headlights



Removal & Installation
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. For vehicles equipped with 3.5L engine, remove the 7 clips and cool air intake duct seal
    1. Put protective tape around the front bumper assembly.
    2.  

  6.  
  7. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip. Use the same procedures for the RH side and LH side.
  8.  
  9. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
  10.  
  11. Disengage the 2 claws and disconnect the front bumper assembly.
  12.  
  13. Use the same procedures for the RH side and LH side.
  14.  
  15. If the vehicle is equipped with fog lights, disconnect each connector.
  16.  
  17. Remove the front bumper assembly.
  18.  
  19. Remove the headlight assembly bolt and 2 screws.
  20.  
  21. Disconnect the connectors and remove the headlight assembly.

    Click image to see an enlarged view

    Fig. Identifying front bumper components and headlight assembly



    Click image to see an enlarged view

    Fig. Removing headlight assembly

  22.  

To install:

  1. Connect the connectors, then install the headlight assembly with the bolt and 2 screws and tighten to 32 inch lbs. (3.6 Nm).
  2.  
  3. The remainder of installation is the reverse of the removal procedure.
  4.  

 
label.common.footer.alt.autozoneLogo