Camry 2008-2009

Oil Pressure Sensor

Print

Removal & Installation



Specific to:

Toyota Camry 2007-2008

  1. Remove the engine under cover(s).
  2.  
  3. Remove the engine oil pressure switch assembly, as follows:
    1. Disconnect the oil pressure switch connector.
    2.  
    3. Using a 24 mm deep socket wrench, remove the oil pressure switch.
    4.  

  4.  

To install:

  1. Apply adhesive to 2 or 3 threads of the oil pressure switch. Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
  2.  
  3. Using a 24 mm deep socket wrench, install the oil pressure switch and tighten to 11 ft. lbs. (15 Nm).
    NOTE
    Do not start the engine for at least 1 hour after installation.

  4.  
  5. Connect the oil pressure switch assembly connector.
  6.  
  7. Check for oil leaks.
  8.  
  9. Install the engine under cover(s).
  10.  

Testing



Specific to:

Toyota Camry 2007-2008

  1. Disconnect the connector from the engine oil pressure switch.
  2.  
  3. Ground the terminal on the wire harness side, then measure the resistance. Standard Resistance: Engine idling, Below 1 ohm, Engine stopped, 10 kilo ohms or higher. If the value is not as specified, replace the engine oil pressure switch.
  4.  

 
label.common.footer.alt.autozoneLogo