Camry 2008-2009

Automatic Transaxle

Print

Drain & Refill



Hybrid

Specific to:

Toyota Camry 2009-2010

  1. Using a 10 mm socket hexagon wrench, remove the filler plug and gasket.
  2.  
  3. Using a 10 mm socket hexagon wrench, remove the drain plug and gasket.
  4.  
  5. Using a 10 mm socket hexagon wrench, install the drain plug and a new gasket. Tighten to 29 ft. lbs. (39 Nm).

    Click image to see an enlarged view

    Fig. Locating the filler and drain plugs

  6.  
  7. Add hybrid transaxle fluid. Fill capacity is 4.3 qts (4.1 L).
  8.  
  9. Check that the fluid surface is within 0.20 inch (5 mm) from the inner surface of the differential filler plug opening.
    NOTE
    Stop the vehicle on a level surface.


    NOTE
    Recheck the transaxle fluid level after driving following fluid replacement.


    NOTE
    Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.

  10.  
  11. Check the oil level.

    Click image to see an enlarged view

    Fig. Checking the oil level

  12.  
  13. Using a 10 mm socket hexagon wrench, install the filler plug and a new gasket. Tighten to 29 ft. lbs. (39 Nm).
  14.  
  15. Using a 10 mm socket hexagon wrench, remove the filler plug and gasket.
  16.  
  17. Check that the fluid surface is within 5 mm (0.20 in.) from the inner surface of the differential filler plug opening.
    NOTE
    Stop the vehicle on a level surface.


    NOTE
    Recheck the transaxle fluid level after driving following fluid replacement.


    NOTE
    Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.

  18.  
  19. Check for leaks if the fluid level is low.
  20.  
  21. Using a 10 mm socket hexagon wrench, install the filler plug and a new gasket. Tighten to 29 ft. lbs. (39 Nm).
  22.  

Non-Hybrid Models

Specific to:

Toyota Camry 2009-2010


CAUTION
The U660E and U760E automatic transaxle does not have an oil filler tube and oil level gauge. When adding fluid, add fluid through the refill hole on the transaxle case. The fluid level can be adjusted by draining excess fluid (allowing excess fluid to overflow) through the overflow tube of the oil pan.



Click image to see an enlarged view

Fig. Fluid filling procedure

 
label.common.footer.alt.autozoneLogo