Camry 2008-2009

Panels & Trim

Print

Removal & Installation



Door Trim Panel
Front Door

Specific to:

Toyota Camry 2009-2010

  1. Remove the front door lower frame bracket garnish.
    1. Disengage the 2 clips and remove the front door lower frame bracket garnish.
    2.  

  2.  
  3. Remove the front door inside handle bezel plug.
    1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.
    2.  

  4.  
  5. Remove the assist grip cover.
    1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.
    2.  

  6.  
  7. Remove the courtesy light assembly. Disconnect the connector.
  8.  
  9. Remove the front door trim board sub assembly.
    1. Remove the 3 screws and clip (A).
    2.  
    3. Using a clip remover, disengage the 9 clips.

      Click image to see an enlarged view

      Fig. Removing the front door trim board sub assembly



      Click image to see an enlarged view

      Fig. Exploded view of the front door

    4.  
    5. Pull out and up on the front door trim board.
    6.  
    7. Disengage the reference bosses from the front door panel.
    8.  
    9. Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.
    10.  

  10.  

To install:

To install, reverse the removal procedure.

Rear Door

Specific to:

Toyota Camry 2009-2010

  1. Remove the rear door inside handle bezel plug.
    1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.
    2.  

  2.  
  3. Remove the door assist grip cover.
    1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the door assist grip cover.
    2.  

  4.  
  5. Remove the door trim board sub assembly.
    1. Remove the 3 screws.
    2.  
    3. Using a clip remover, disengage the 7 clips.
    4.  
    5. Raise the rear door trim board to disengage the 4 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.
    6.  
    7. Disconnect the connector.

      Click image to see an enlarged view

      Fig. Removing the rear door trim panel



      Click image to see an enlarged view

      Fig. Exploded view of the rear door

    8.  

  6.  

 
label.common.footer.alt.autozoneLogo