Camry 2008-2009

Removal & Installation

Print

Specific to:

Toyota Camry 2007-2008


CAUTION
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the vehicle.

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect cable from negative battery terminal.
    CAUTION
    Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying.

  4.  
  5. Place front wheels facing straight ahead.
  6.  
  7. Remove steering pad assembly.
  8.  
  9. Remove steering wheel assembly, as follows:
    1. Remove the steering wheel assembly set nut.
    2.  
    3. Put matchmarks on the steering wheel assembly and the steering main shaft.
    4.  
    5. Disconnect the connectors from the spiral cable.
    6.  
    7. Using SST: 09950-50013, remove the steering wheel assembly.

      Click image to see an enlarged view

      Fig. Removing the steering wheel

    8.  

  10.  

To install:

  1. Center spiral cable.
  2.  
  3. Align the matchmarks on the steering wheel assembly and the steering main shaft assembly.
  4.  
  5. Install the steering wheel assembly with the set nut and tighten to 37 ft. lbs. (50 Nm).
  6.  
  7. Connect the connector.
  8.  
  9. Install the steering pad assembly.
  10.  
  11. Inspect the steering wheel steering point. If the steering wheel is not properly centered, remove and refit to center.
  12.  
  13. Connect cable to negative battery terminal.
  14.  
  15. Inspect the SRS warning light.
  16.  

Specific to:

Toyota Camry 2009-2010


CAUTION
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the vehicle.

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect cable from negative battery terminal.
    CAUTION
    Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying.

  4.  
  5. Place front wheels facing straight ahead.
  6.  
  7. Remove steering pad assembly.
  8.  
  9. Remove steering wheel assembly, as follows:
    1. Remove the steering wheel assembly set nut.
    2.  
    3. Put matchmarks on the steering wheel assembly and the steering main shaft.
    4.  
    5. Disconnect the connectors from the spiral cable.
    6.  
    7. Using SST: 09950-50013, remove the steering wheel assembly.

      Click image to see an enlarged view

      Fig. Removing the steering wheel

    8.  

  10.  

To install:

  1. Center spiral cable.
  2.  
  3. Align the matchmarks on the steering wheel assembly and the steering main shaft assembly.
  4.  
  5. Install the steering wheel assembly with the set nut and tighten to 37 ft. lbs. (50 Nm).
  6.  
  7. Connect the connector.
  8.  
  9. Install the steering pad assembly.
  10.  
  11. Inspect the steering wheel steering point. If the steering wheel is not properly centered, remove and refit to center.
  12.  
  13. Connect cable to negative battery terminal.
  14.  
  15. Inspect the SRS warning light.
  16.  

 
label.common.footer.alt.autozoneLogo