Canyon, Colorado 2006-2007

Crankshaft Position Sensor

Print

Removal & Installation





Click image to see an enlarged view

Fig. Disconnecting CKP electrical connector



Click image to see an enlarged view

Fig. Removing camshaft position sensor -intake

  1. Raise and support the vehicle.
  2.  
  3. Disconnect the engine wiring harness electrical connector (3) from the Crankshaft Position (CKP) sensor (1).
  4.  
  5. Remove the CKP sensor bolt.
  6.  
  7. Remove the CKP sensor from the engine block. Discard the O-ring seals.
  8.  
  9. To install, reverse removal procedure. Install new O-ring seals to the CKP sensor. Lightly lubricate the O-ring seals with clean engine oil. Add sealer GM P/N 12346004 to the CKP sensor bolt threads.
  10.  
  11. Tighten the camshaft position (CKP) sensor bolt to 89 inch lbs. (10 Nm).
  12.  

 
label.common.footer.alt.autozoneLogo