Canyon, Colorado 2006-2007

Ignition Coil

Print

Removal & Installation



  1. Remove the air cleaner resonator and outlet duct.
  2.  
  3. Disconnect the engine wiring harness electrical connector from the oil pressure sensor.
  4.  
  5. Disconnect the engine wiring harness retainer from the oil filter adapter.
  6.  
  7. Disconnect the engine wiring harness retainers from the power steering pump.
  8.  
  9. Disconnect the engine wiring harness electrical connectors from the camshaft position sensor and actuator solenoid valve.
  10.  
  11. Disconnect the engine wiring harness retainer from the camshaft cover.
  12.  
  13. Disconnect the engine wiring harness electrical connectors from the coolant temperature sensor, fuel injector harness, ignition coils and oxygen sensor.
  14.  
  15. Carefully disengage the engine wiring harness conduit from the camshaft cover, and position aside.
  16.  
  17. Remove the ignition coil bolts.
  18.  
  19. Remove the ignition coils from the camshaft cover.
  20.  

To install:

  1. Install the ignition coils to the camshaft cover.
  2.  
  3. Install the ignition coil bolts and tighten to 89 inch lbs. (10 Nm).
  4.  
  5. Carefully install the engine wiring harness conduit to the camshaft cover.
  6.  
  7. Connect the engine wiring harness electrical connectors to the coolant temperature sensor, fuel injector harness, ignition coils and oxygen sensor.
  8.  
  9. Connect the engine wiring harness retainer to the camshaft cover.
  10.  
  11. Connect the engine wiring harness electrical connectors to the camshaft position sensor and actuator solenoid valve.
  12.  
  13. Connect the engine wiring harness retainers to the power steering pump.
  14.  
  15. Connect the engine wiring harness retainer to the oil filter adapter.
  16.  
  17. Connect the engine wiring harness electrical connector to the oil pressure sensor.
  18.  

 
label.common.footer.alt.autozoneLogo