Canyon, Colorado 2006-2007

Intake Manifold

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable
     
    Air intake assembly
     
    Throttle body
     
    Battery and battery box
     
    Dipstick and tube
     
    Brake booster hose
     
    Manifold Absolute Pressure (MAP) sensor connector and harness retainer
     
    PCV tube
     
    Alternator
     
    Engine wiring harness retainer
     
    Upper 2 engine wiring harness bracket bolts
     
    Raise and support vehicle
     
    Left front wheel
     
    Left front fender inner liner
     
    Wiring harness retainers for battery cable, engine and MAP sensor
     
    Engine wiring harness bracket from the intake manifold
     
    Intake manifold bolts
     
    Lower the vehicle
     
    Intake manifold and gasket

    Click image to see an enlarged view

    Fig. Intake manifold mounting-Canyon & Colorado

     

  4.  

To install:

  1. Install or connect the following:

    Intake manifold with new gasket
     
    Raise and support the vehicle
     
    Tighten the intake manifold bolts, working from the center outward, to 89 inch lbs. (10 Nm)
     
    Engine wiring harness bracket
     
    Wiring harness retainers for the battery cable, engine and MAP sensor
     
    Left front fender inner liner
     
    Left front wheel
     
    Lower the vehicle
     
    Upper 2 engine wiring harness bracket bolts
     
    Engine wiring harness retainer
     
    Alternator
     
    PCV tube
     
    MAP sensor connector and harness retainer
     
    Brake booster hose
     
    Dipstick and tube
     
    Throttle body
     
    Negative battery cable
     

  2.  
  3. Start the engine and check for leaks.
  4.  

 
label.common.footer.alt.autozoneLogo