Canyon, Colorado 2006-2007

Throttle Body

Print

Removal & Installation



  1. Relieve the fuel system pressure.
  2.  
  3. Remove the air cleaner resonator and outlet duct.
  4.  
  5. Disconnect the evaporative emission (EVAP) canister purge pipe from the throttle control module.
  6.  
  7. Disconnect the throttle control module electrical connector.
  8.  
  9. Remove the throttle control module bolts.
  10.  
  11. Remove the throttle control module and the seal from the intake manifold.
  12.  
  13. Clean the gasket surface.
  14.  

To install:

  1. Insert a new seal into the intake manifold groove.
  2.  
  3. Position the throttle control module to the intake manifold.
  4.  
  5. Install the throttle control module bolts and tighten to 89 inch lbs. (10 Nm).
  6.  
  7. Connect the throttle control module electrical connector.
  8.  
  9. Connect the EVAP canister purge pipe to the throttle control module.
  10.  
  11. Install the air cleaner resonator and outlet duct.
  12.  

 
label.common.footer.alt.autozoneLogo