Canyon, Colorado 2006-2007

Control Arms & Links

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise and support the vehicle.
  4.  
  5. Support the rear axle at ride height.
    CAUTION
    Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.

  6.  
  7. Remove the stabilizer shaft link upper nut.
  8.  
  9. Remove the stabilizer shaft link lower nut.
  10.  
  11. Remove the stabilizer shaft link.
  12.  

To install:


CAUTION
Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.

  1. Install the stabilizer shaft link.
  2.  
  3. Install the stabilizer shaft link mounting nuts.
  4.  
  5. Tighten the stabilizer bar link upper and lower mounting nut to 32 ft. lbs. (44 Nm).
  6.  
  7. Remove the axle support. Lower the vehicle.
  8.  

 
label.common.footer.alt.autozoneLogo