Caravan, Town & Country 2006-2007

Hydraulic Control Module

Print

Removal & Installation



  1. Remove the ABS control module assembly.
  2.  
  3. If not equipped with traction control, remove the three screws attaching the hydraulic control module to the control module.
  4.  
  5. If equipped with traction control, remove the four screws attaching the hydraulic control module to the control module.
  6.  
  7. Separate the control module assemblies.
  8.  

To install:

  1. Clean any debris off the mating surfaces of the control modules.
    NOTE
    When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant.

  2.  
  3. If the seals on the components are not new, they must be replaced. Each of the solenoid valve stem seals must be replaced; do not reuse solenoid valve stem seals. The pump/motor connector O-ring should also be replaced if not new.
  4.  
  5. Align the components and install the control module assemblies together.
  6.  
  7. If not equipped with traction control, install the three screws attaching the hydraulic control module. Tighten the mounting screws to 17 inch lbs. (2 Nm).
  8.  
  9. If equipped with traction control, install the four screws attaching the hydraulic control module. Tighten the mounting screws to 17 inch lbs. (2 Nm).
  10.  
  11. Install the ABS control module assembly in the vehicle.
  12.  

 
label.common.footer.alt.autozoneLogo