Caravan, Town & Country 2006-2007

Mirrors

Print

Power Mirrors



Diagnosis & Testing

Any diagnosis of the Power Mirror system should begin with the use of scan tool. For information on the use of the scan tool, refer to the appropriate Diagnostic Service information.


NOTE
For complete circuit diagrams, refer to the appropriate wiring information.

  1. Check the fuses in the Power Distribution Center (PDC) and the junction block. If OK, go to Step 2. If not OK, repair the shorted circuit or component as required and replace the faulty fuse(s).
  2.  
  3. Check for battery voltage at the fuse in the junction block. If OK, go to Step 3. If not OK, repair the open circuit to the PDC as required.
  4.  
  5. Disconnect and isolate the battery negative cable. Remove the driver side power window switch and bezel assembly and unplug the wire harness connector from the power mirror switch. Connect the battery negative cable. Check for battery voltage at the fused B(+) circuit cavity in the door wire harness half of the power mirror switch wire harness connector. If OK, go to Step 4. If not OK, repair the open circuit to the junction block as required.
  6.  
  7. Disconnect and isolate the battery negative cable. Check for continuity between the ground circuit cavity in the door wire harness half of the power mirror switch wire harness connector and a good ground. There should be continuity. If not OK, repair open in the ground circuit.
  8.  

Removal & Installation
Motor
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect and isolate the negative battery cable.
  4.  
  5. Using a trim stick or equivalent, gently pry out on mirror trim cover.
  6.  
  7. Open door and remove the three retaining screws.
  8.  
  9. Disconnect the wire connector and remove mirror assembly from the vehicle.
  10.  
  11. Installation is the reverse of removal.
  12.  

Switch
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect and isolate the battery negative cable.
  4.  
  5. Remove instrument panel lower cover.
  6.  
  7. From behind headlamp switch assembly, depress retaining tabs and push switch from instrument panel.
  8.  
  9. Disconnect wire connector from power mirror switch.
  10.  
  11. Disengage lock tabs above and below the mirror switch.
  12.  
  13. Remove power mirror switch from headlamp switch bezel.
  14.  
  15. Installation is the reverse of removal.
  16.  

 
label.common.footer.alt.autozoneLogo