Catera 2000-2001

Arming The System

Print

  1. Turn the steering wheel so that the wheels are pointing straight ahead.
  2.  
  3. Turn the ignition switch to the LOCK position and remove the key.
  4.  
  5. Connect the side impact module RF connector.
  6.  
  7. Install the Connector Position Assurance (CPA) from the inflatable restraint side impact module RF connector.
  8.  
  9. Connect the seat belt pretensioner RF connector to the connector.
  10.  
  11. Install the right hand outer seat track cover.
  12.  
  13. Connect the side impact module LF connector.
  14.  
  15. Install the CPA from the inflatable restraint side impact module LF connector.
  16.  
  17. Connect the seat belt pretensioner LF connector to the connector.
  18.  
  19. Install the left hand outer seat track cover.
  20.  
  21. Connect the IP module connector.
  22.  
  23. Install the CPA to the IP module connector.
  24.  
  25. Install the inflatable restraint Instrument Panel (IP) module cover.
  26.  
  27. Connect the inflatable restraint steering wheel module 2-way connector
  28.  
  29. Connect the CPA to the inflatable restraint steering wheel module 2-way connector.
  30.  
  31. Install the inflatable restraint steering wheel module to the steering wheel.
  32.  
  33. Install the two TORX® screws to the back of the steering wheel and tighten to 72 inch lbs. (8 Nm).
  34.  
  35. Reconnect the negative battery cable.
  36.  
  37. Wait at least 1 minute for the capacitors to recharge.
  38.  
  39. While staying away from the inflator modules, turn the key to the RUN position. The air bag warning lamp should turn ON for 3-4 seconds, then turn OFF.
  40.  

 
label.common.footer.alt.autozoneLogo