Cavalier, Sunfire 2001-2005

Removal & Installation

Print

Ignition Coil Module



2.2L Engines
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the ignition coils from the module.
  4.  
  5. Remove the module from the assembly plate.
  6.  
  7. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. The Ignition Module or (ICM), is located under the coils



    Click image to see an enlarged view

    Fig. The ignition coil/module location-2.2L engines

  8.  

2.4L Engines
  1. Disconnect the negative battery cable.
  2.  
  3. Detach the Electronic Ignition Control Module (ICM) electrical connector.
  4.  
  5. Unfasten the coil and module-to-cam housing bolts, then remove the coil and ignition module assembly from the engine.
  6.  
  7. Unfasten the housing-to-cover screws, then pull the housing from the cover.
  8.  
  9. Detach the coil harness connector from the module.
  10.  
  11. Unfasten the module-to-cover screws, then remove the module.
    WARNING
    Do NOT wipe the grease from the module or coil if the same module is to be replaced. If a new module is to be installed, a package of silicone grease will be included with it. Spread the grease on the metal face of the module and on the cover where the module seats. This grease is necessary for module cooling.

  12.  
  13. Installation is the reverse of the removal procedure.
  14.  

 
label.common.footer.alt.autozoneLogo