Chevrolet Chevette/1000 1976-1988 Repair Guide

Control Head Assembly

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1Heater and A/C control head removal and installation



Click image to see an enlarged view

Fig. Fig. 2A/C temperature control cable routing



Click image to see an enlarged view

Fig. Fig. 3Location and routing of the A/C vacuum hoses



Click image to see an enlarged view

Fig. Fig. 4View of the heater bowden cable attachment

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the four instrument panel bezel attaching screws located above and below the air conditioning control head assembly.
  4.  
  5. Remove the knob and related hardware from the radio controls, if so equipped.
  6.  
  7. Remove the instrument panel bezel.
  8.  
  9. Remove the three heater/air conditioning control-to-instrument panel attaching screws.
  10.  
  11. Slide the control out from the dash opening, being careful not to kink the bowden cables or damage the vacuum hoses or connectors.
  12.  
  13. Disconnect the vacuum and electrical connectors and bowden cables and remove the control head.
  14.  
  15. Installation is the reverse of removal.
  16.  

 
label.common.footer.alt.autozoneLogo