Chevrolet Chevette/1000 1976-1988 Repair Guide

Back-Up Light Switch

Print

REMOVAL & INSTALLATION



  1. Set the brake and raise and support the vehicle safely.
  2.  
  3. Pull the electrical connector from the switch. The switch is located horizontally at the rear of the transmission on either the right or left side.
  4.  
  5. Using a box-end wrench, remove the switch from the rear of the transmission case.
  6.  
  7. Install the switch using a new gasket, check the operation of the switch by placing the transmission in the reverse detent.
  8.  

 
label.common.footer.alt.autozoneLogo