Chevrolet Full Size Cars 1979-1989

Seat Belt System

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1 Common seat belt buckle mounting



Click image to see an enlarged view

Fig. Fig. 2 Front seat outer lap belt mounting

  1. Remove the door pillar trim covers and/or rear seat, as required for access. Remove the cover from the anchor plate.
  2.  
  3. Remove the attaching bolt, anchor plate and washer.
  4.  
  5. Remove the bolt cover from the rear of the retractor assembly.
  6.  
  7. Remove the bolt retaining the retractor to the floor panel, then remove the retractor.
  8.  
  9. Remove the buckle assembly from the floor panel.
  10.  
  11. Remove the cap which conceals the buckle assembly bolt and remove the bolt.
  12.  
  13. Remove the seat belt warning wire from the drivers side buckle and remove the buckle assembly from the vehicle.
  14.  
  15. Installation is the reverse of removal. Tighten all bolts to 31-35 ft. lbs. (43-48 Nm).
  16.  

 
label.common.footer.alt.autozoneLogo