Chevrolet Full-size Cars 1968-1978 Repair Guide

Determining Axle Ratio


An axle ratio is obtained by dividing the number of teeth on the drive pinion gear into the number of teeth on the ring gear. For instance, on a 4.11 ratio, the driveshaft will turn 4.11 times for every turn of the rear wheel.

The most accurate way to determine the axle ratio is to drain the differential, remove the cover and count the number of teeth on the ring and pinion.

An easier method is to jack and support the vehicle so that both rear wheels are off the ground, make a chalk mark on the rear wheel and the driveshaft. Block the front wheels and put the transmission in Neutral. Turn the rear wheel one complete revolution and count the number of turns made by the driveshaft. The number of driveshaft rotations is the axle ratio. More accuracy can be obtained by going more than one tire revolution and dividing the result by the number of tire rotations.

The axle ratio is also identified by the axle serial number prefix on the axle; the axle ratios are listed in dealer's parts guide according to prefix number. Some axles have a tag on the cover, refer to for more identification information.