Chevrolet Nova/ChevyII 1962-1979

Introduction

Print



Click image to see an enlarged view

Fig. Fig. 1 Typical lifting points-1974-79 vehicles shown, other years similar. See your owners manual for specific applications



Click image to see an enlarged view

Fig. Fig. 2 View of the front and rear bumper jacking points-1973 vehicle shown, others similar



Click image to see an enlarged view

Fig. Fig. 3 A good quality floor jack is the safe way to raise the front of your vehicle



Click image to see an enlarged view

Fig. Fig. 4 If you plan to work underneath the vehicle, ALWAYS use jackstands to support it



Click image to see an enlarged view

Fig. Fig. 5 Make sure to use a proper capacity jack to raise the rear end of the vehicle



Click image to see an enlarged view

Fig. Fig. 6 Raise the rear of the vehicle and place jackstands under the rear axle to support it

Your vehicle was supplied with a jack for emergency road repairs. This jack is fine for changing a flat tire or other short term procedures not requiring you to go beneath the vehicle. If it is used in an emergency situation, carefully follow the instructions provided either with the jack or in your owner's manual. Do not attempt to use the jack on any portions of the vehicle other than specified by the vehicle manufacturer. Always block the diagonally opposite wheel when using a jack.

A more convenient way of jacking is the use of a garage or floor jack.

Never place the jack under the radiator, engine or transmission components. Severe and expensive damage will result when the jack is raised. Additionally, never jack under the floorpan or bodywork; the metal will deform.

Whenever you plan to work under the vehicle, you must support it on jackstands or ramps. Never use cinder blocks or stacks of wood to support the vehicle, even if you're only going to be under it for a few minutes. Never crawl under the vehicle when it is supported only by the tire-changing jack or other floor jack.

Always position a block of wood or small rubber pad on top of the jack or jackstand to protect the lifting point's finish when lifting or supporting the vehicle.

Small hydraulic, screw, or scissors jacks are satisfactory for raising the vehicle. Drive-on trestles or ramps are also a handy and safe way to both raise and support the vehicle. Be careful though, some ramps may be too steep to drive your vehicle onto without scraping the front bottom panels. Never support the vehicle on any suspension member (unless specifically instructed to do so by a repair manual) or by an underbody panel.

 
label.common.footer.alt.autozoneLogo