Chrysler Caravan/Voyager/Town and Country 1996-1999

HVAC Control Panel

Print

REMOVAL & INSTALLATION



Front Control Switch

See Figures 1, 2, 3, 4, 5, 6, 7 and 8



Click image to see an enlarged view

Fig. Fig. 1: To remove the HVAC control panel, detach the cup holder ...



Click image to see an enlarged view

Fig. Fig. 2: ... and the lower trim ...



Click image to see an enlarged view

Fig. Fig. 3: ... to access the lower control unit mounting screws



Click image to see an enlarged view

Fig. Fig. 4: The upper mounting screws are above the radio

  1. Disconnect the negative battery cable.
  2.  
  3. Pull the cup holder out, then remove the small plastic trim piece between the cup holder and the HVAC control panel/radio bezel.
  4.  
  5. Loosen the 2 lower and 2 upper mounting screws, then remove the HVAC control panel/radio bezel.
  6.  
  7. Disengage the wiring connectors from behind the HVAC control panel switches.
  8.  

To install:


Click image to see an enlarged view

Fig. Fig. 5: Once the screws are removed, unclip the light bulb from the cup holder bracket ...



Click image to see an enlarged view

Fig. Fig. 6: ... and slide it out ...



Click image to see an enlarged view

Fig. Fig. 7: ... to allow the control panel to be removed



Click image to see an enlarged view

Fig. Fig. 8: Once the unit is detached, unplug the electrical connectors

  1. Plug the wiring connectors into the control panel switches.
  2.  
  3. Position the HVAC control panel/radio bezel into the instrument panel. Install and tighten the 2 upper and 2 lower mounting screws.
  4.  
  5. Install the small plastic trim piece between the cup holder and the control panel by firmly pushing in to engage the retaining clips.
  6.  
  7. Connect the negative battery cable.
  8.  
  9. Test the control panel for proper function.
  10.  

Rear Heater-A/C Control Switch
  1. Remove the HVAC control panel/radio bezel.
  2.  
  3. Disengage the wiring connectors from behind the HVAC control panel switches.
  4.  
  5. Remove the screw holding the rear heater-A/C switch to the back of the HVAC control panel/radio bezel.
  6.  
  7. Disengage the hook securing the bottom of the switch to the back of the panel.
  8.  
  9. Remove the switch.
  10.  
  11. Installation is the reverse of the removal procedure.
  12.  

 
label.common.footer.alt.autozoneLogo