Chrysler Caravan/Voyager/Town n Country 1984-1995

Rear Halfshaft

Print

REMOVAL & INSTALLATION



  1. Raise and safely support the rear of the vehicle.
  2.  
  3. Remove the rear wheel.
  4.  
  5. Remove the cotter pin, nut, lock and spring washer from the rear hub.
  6.  
  7. Remove the inner halfshaft retaining bolts.
  8.  
  9. The halfshaft is spring loaded, push it in slightly and then tilt it down to remove it. Pull it out from under the vehicle.
  10.  

To install:
  1. Insert the end of the halfshaft into the rear hub assembly.
  2.  
  3. Position it on the rear carrier unit and install the retaining bolts.
  4.  
  5. Tighten the retaining bolts to 45 ft. lbs. (61 Nm).
  6.  
  7. Install the hub nut, spring and lock washers, and cotter pin.
  8.  
  9. Install the wheel and tire assembly.
  10.  

 
label.common.footer.alt.autozoneLogo