Chrysler Cirrus/Stratus/Sebring/Avenger/Breeze 1995-1998

Bleeding the ABS System

Print

The bleeding procedure is a 2-step process, one of which will require use of the DRB scan tool or its equivalent. Bleed the system as follows:

  1. Locate the diagnostic connector under the dash panel next to the left kick panel.
  2.  
  3. Connect the DRB scan tool to the connector. Install the correct cartridge for the Anti-Lock Brake systems. Check to make sure the CAB or ABS-ECU does not have any fault codes stored in it. If it does, remove them using the DRB scan tool.
  4.  
  5. Bleed the base brake system using the non-ABS manual or pressure bleeding method as outlined earlier in this section. Be sure to bleed the brake system in the correct sequence.
  6.  
  7. Utilizing the scan tool, go to the "Bleed ABS" routine. Firmly apply the brake pedal to initiate the "Bleed ABS" cycle one time. Release the brake pedal.
  8.  
  9. Using the scan tool, go on to bleed the Anti-Lock Brake System according to the scan tool literature.
  10.  
  11. Once bleeding with the scan tool is complete, repeat the conventional bleed procedure for the base brake system.
  12.  
  13. Perform this procedure until the brake fluid flows clear and free of air bubbles. Check brake fluid level periodically to prevent the reservoir from running low on fluid. Top off the master cylinder reservoir to the proper level with DOT 3 type brake fluid only.
  14.  
  15. Road test the vehicle to check for proper brake system operation.
  16.  

 
label.common.footer.alt.autozoneLogo