Chrysler Cirrus/Stratus/Sebring/Avenger/Breeze 1995-1998

Crankshaft Damper

Print

REMOVAL & INSTALLATION



See Figures 1 through 5

  1. Disconnect the negative battery cable.
  2.  
  3. Raise and safely support the vehicle. Remove the right side wheel and tire assembly.
  4.  
  5. Remove the right inner splash shield.
  6.  
  7. Remove the accessory drive belts.
  8.  
  9. Break the crankshaft damper bolt loose, but do not remove it.
  10.  
  11. Remove the crankshaft damper. If necessary, attach a suitable 3-jawed puller to the crankshaft damper, then tighten the center bolt and remove the damper bolt and damper.
  12.  



Click image to see an enlarged view

Fig. Fig. 1: Remove the right side inner fender splash shield



Click image to see an enlarged view

Fig. Fig. 2: From below the vehicle, remove the accessory drive belts



Click image to see an enlarged view

Fig. Fig. 3: If necessary, use a prying tool to wedge between the engine block and damper spoke hole, then loosen the center bolt



Click image to see an enlarged view

Fig. Fig. 4: Remove the crankshaft damper center bolt and washer



Click image to see an enlarged view

Fig. Fig. 5: Pull off the crankshaft damper, or remove using a 3-jawed puller tool

To install:
  1. Install the crankshaft damper. It may be necessary to install the crankshaft damper using an M12-1.75 x 150mm bolt, washer, thrust bearing and nut from the crankshaft damper installation tool kit 6792 or equivalent.
  2.  
  3. Install the crankshaft damper bolt and tighten to the following specifications:

    2.0L SOHC and DOHC engines-105 ft. lbs. (142 Nm).
     
    2.4L engine-100 ft. lbs. (135 Nm)
     
    2.5L engine-134 ft. lbs. (182 Nm)
     

  4.  
  5. Install the accessory drive belts.
  6.  
  7. Install the right inner splash shield. Install the right side wheel and tire assembly.
  8.  
  9. Carefully lower the vehicle, then connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo