Chrysler Cirrus/Stratus/Sebring/Avenger/Breeze 1995-1998

Outside Mirrors

Print

REMOVAL & INSTALLATION



See Figures 1 through 6



Click image to see an enlarged view

Fig. Fig. 1: Detach the electrical connector from the power side view mirror



Click image to see an enlarged view

Fig. Fig. 2: Remove the 2 mirror trim panel mounting screws



Click image to see an enlarged view

Fig. Fig. 3: Remove the side view mirror interior trim panel from the door



Click image to see an enlarged view

Fig. Fig. 4: If equipped, remove the fastener covers from the door panel



Click image to see an enlarged view

Fig. Fig. 5: Remove the 3 side view mirror-to-door mounting fasteners



Click image to see an enlarged view

Fig. Fig. 6: Pull the side view mirror assembly out from the door

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the door trim panel, as outlined later in this section.
  4.  
  5. If equipped with a manually operated mirror, remove the control knob.
  6.  
  7. If equipped with power mirrors, perform the following:
    1. Remove the watershield.
    2.  
    3. Detach the electrical connector from the power mirror motor.
    4.  

  8.  
  9. Remove the mirror trim panel mounting screws. Remove the side view mirror interior trim panel from the door.
  10.  
  11. If equipped, remove the fastener covers from the door panel.
  12.  
  13. Unfasten the bolts holding the mirror to the door panel, then remove the mirror from the vehicle.
  14.  

To install:
  1. Position the side view mirror on the vehicle, then install the nuts attaching the mirror to the door panel.
  2.  
  3. If equipped with power mirrors, perform the following:
    1. Attach the electrical connector to the power window motor.
    2.  
    3. Install the watershield.
    4.  

  4.  
  5. If equipped, install the fastener covers to the door panel.
  6.  
  7. Install the side view mirror cover.
  8.  
  9. If equipped with a manually operated mirror, install the control knob.
  10.  
  11. Install the door trim panel, as outlined later in this section.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo