Chrysler Cirrus/Stratus/Sebring/Avenger/Breeze 1995-1998

Power Seat Motor

Print

REMOVAL & INSTALLATION



Sebring Convertible
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front seat from the vehicle.
  4.  
  5. Remove the front seat back.
  6.  
  7. Separate the power seat switch and wiring harness from the seat adjuster.
  8.  

To install:
  1. Install the power seat switch and harness to the seat adjuster.
  2.  
  3. Install the front seat back.
  4.  
  5. Install the front seat into the vehicle.
  6.  
  7. Connect the negative battery cable.
  8.  

Sebring Coupe and Avenger

See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front seat.
  4.  
  5. Remove the bolts which mount the gear box to the left and right ends of the rails.
  6.  
  7. Remove the gear shaft from the left side.
  8.  
  9. Pull the gear box at the right side toward you to disengage the gear shaft from the side rail.
  10.  
  11. Remove the power seat motor.
  12.  
  13. Installation is the reverse of the removal steps.
  14.  



Click image to see an enlarged view

Fig. Fig. 1: Power seat motor (gear box) assembly

 
label.common.footer.alt.autozoneLogo